I find that quite often the cleanup of smart walls does not work correctly. The attached screen shot is one such example. Is there a secret trick to wall cleanups where diferent wall types are concerned. Or should I jst use walls without cavities and fills and draw fills in 2D later.
I am not tring to be negative. Just trying to use th smart features.
Thanks Mark. The example I posted was made up of two 250 mm brick veneer walls (with a cavity) and a 230 mm thick solid brick wall. The brick veneer walls were cleaned up using 2 line trim. The solid brick wall was cleaned up using 1 line trim.
Walter DataCAD user since V3.6E DataCAD V18 subscriber
that's a tough one to show, and you may have to compromise a little. for the short outer solid brick wall, change the z-base to not match the other walls. If you are modeling this for 3d, you can make it the smallest amount that you can. The compromise will be a solid line that will separate the walls.
Roger Donaldson AIA CSI CDT LEED AP BD+CNCARB abUsing Datacad since 1986, ver 20.01.01.01 (SE) http://www.RogerDonaldsonArchitect.com