Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
#69082 by wvar
Sat May 28, 2016 9:59 pm
Does anyone know whether Get Snap can be used when drawing slabs. If so what is the trick to getting Get Snap to work.

For some reason I cannot get it to work.

Get Snap works fine in other situations.

Restarting the PC makes no difference.
#69084 by joshhuggins
Sat May 28, 2016 11:18 pm
It's working here as far as I can tell with X&Y using Rel Cart. Can you take a screen shot of what you were trying to do and where your start point is and what you are trying to snap to with which command?
#69085 by wvar
Sat May 28, 2016 11:51 pm
Thanks Josh

I am using Relative Cartesian.

In the attached example I am trying to create point D using Get Snap Y at A.
(13.28 KiB) Downloaded 100 times

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984