Page 1 of 1
Drawing Slabs Using Get Snap
Posted:
Sat May 28, 2016 9:59 pm
by wvar
Does anyone know whether Get Snap can be used when drawing slabs. If so what is the trick to getting Get Snap to work.
For some reason I cannot get it to work.
Get Snap works fine in other situations.
Restarting the PC makes no difference.
Re: Drawing Slabs Using Get Snap
Posted:
Sat May 28, 2016 11:18 pm
by joshhuggins
It's working here as far as I can tell with X&Y using Rel Cart. Can you take a screen shot of what you were trying to do and where your start point is and what you are trying to snap to with which command?
Re: Drawing Slabs Using Get Snap
Posted:
Sat May 28, 2016 11:51 pm
by wvar
Thanks Josh
I am using Relative Cartesian.
In the attached example I am trying to create point D using Get Snap Y at A.
Re: Drawing Slabs Using Get Snap
Posted:
Sun May 29, 2016 3:59 pm
by joshhuggins
Ahhh gotcha. I don't think it will work snapping to the beginning of the entity you are in the process of creating.