Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#69320 by joncole
Fri Jun 24, 2016 9:19 am
I am quite new to data cad... and having an issue with exporting to sketch up. The model comes in clean and accurate. However instead of being a solid wall with the ability to push/pull... the walls are cavities which makes editing in sketch up a problem.

Is there any settings in data cad which removes this problem. Such as filling the walls... or adding a hatch to walls?
#69327 by Robert Scott
Sat Jun 25, 2016 2:02 pm
Something is off. Can you post a screen shot of the imported SU model?
Also what version of SU are you importing to?
Are you getting the same results exporting and importing a DWG into SU?

Robert

Who is online

Users browsing this forum: No registered users and 29 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984