Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
Since the installation of DataCAD 18.03.00.01, we are not able to switch layers on/off by picking on the drawing screen.
Where do we adjust or set this to work?
Check in the Program Preferences, Misc Tab. Implied Match, the "Shift for Implied Match" should not be checked.
Roger Donaldson AIA CSI CDT LEED AP BD+C NCARB
abUsing Datacad since 1986, ver 20.01.01.01 (SE)http://www
Who is online
Users browsing this forum: No registered users and 2 guests