Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
#69477 by Neil Blanchard
Wed Jul 13, 2016 10:40 am
I had a new issue occur today: i was drawing a wall using the inside, and using perpendicular snap. I draw through a series of parallel lines, and I use the ,< key to undo the last two lines, so I can continue to the next line - if that makes sense?

The issue is, on several occasions, the walls are no longer cleaned to the line I snapped to.

Walls Issue-01.png
#69485 by Mark Bell
Fri Jul 15, 2016 7:04 am
Hi Neil,

Just an idea - have you checked to see if 'nearest' is toggled on in your object snap settings?

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984