Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
#69930 by DBrennfoerder
Mon Oct 10, 2016 9:55 am
Strange problem.

My co-worker has a problem that I can't figure; have never seen before.

All settings and defaults seem to be normal and match my laptop.

But, on James' computer, the DirDis action is 90 degrees off of the desired effect. If we drag right, type in 20, the line enters at straight up. Any line I drag, the output is 90 degrees in a positive (counter clockwise) direction.

How do I fix this?

This is happening in one job file. The file has been saved, closed, and re-opened. Still dirdis is +90 degrees off.

Latest version DataCAD, Win10

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984