Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
#69976 by GARY247
Fri Oct 14, 2016 3:52 pm
Is there any way to turn off info on xref clip cubes so that it stays off? I cannot seem to find anything to turn it off and keep it that way.
#69978 by Roger D
Fri Oct 14, 2016 5:20 pm
??CLIPCUBE_DISPLAY=TRUE in .ini file? this turns on/offf the dashed line that indicates the clip cube??
#69979 by David A. Giesselman
Fri Oct 14, 2016 5:35 pm
Roger D wrote:??CLIPCUBE_DISPLAY=TRUE in .ini file? this turns on/offf the dashed line that indicates the clip cube??

Or from within the Preferences dialog.
clipcube.JPG
clipcube.JPG (84.11 KiB) Viewed 4327 times

Dave
#69981 by GARY247
Sat Oct 15, 2016 7:37 am
Sorry I did not make myself clear. It is when you go to edit a clip cube there is an info box at the bottom which causes everything to show up when you go to make an edit. It seems to appear every time I go to edit a clip cube and I was wondering if there was a way to keep it turned off as it just turns the clip cube in to a cluster mess.
#69990 by Roger D
Sun Oct 16, 2016 12:14 pm
can you post a screen shot, I don't see anything showing up.
#70264 by GARY247
Fri Nov 18, 2016 10:59 am
The base drawings have other clip cubes within the drawing. When I go to edit in another drawing every clip cup in the base drawing then appears blocking out the one I am trying to edit.[attachment=0]clip cube after going to edit.
Attachments
clip cube before going to edit.jpg
clip cube before going to edit.jpg (17.67 KiB) Viewed 4053 times
clip cube after going to edit.jpg
#70266 by GARY247
Fri Nov 18, 2016 2:30 pm
The xref are not on a locked layer and it is done in 2d. I used clip cubes of exterior walls on 4 different building cross sections. This does not happen when I bring in the xref and clip it initially, only when I go to create a new clip cube or edit the existing one.
#70321 by GARY247
Thu Dec 01, 2016 9:15 am
Enable x-clip, x-slip, nesting and dynamic snapping are turned on. When I go to edit the clip cube every xref that it is associated with shows the base drawing shows up(two different drawings). The base drawing has multiple cross sections on it some with x-clips. The only way I seem to get to edit it is to make a new clip cube.
#70550 by GARY247
Tue Jan 03, 2017 5:18 pm
I solved the problem of editing a clip cube and having multiple clip cubes from the base drawing showing up once you click on edit. Right click and go to xref and click off nesting.

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984