Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
#70016 by GARY247
Thu Oct 20, 2016 1:07 pm
Is there any way when doing a clip cube to have any symbols within the clip cube to be included?
#70023 by joshhuggins
Thu Oct 20, 2016 3:20 pm
While in the XClip menu make sure F6 Ignore Z is turned on. Xclips will sometimes clip out things if their zheights are abnormal. With Ignore Z on, it will display everything within the xclip regardless of it's Zheight.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984