Can you clarify the specifics, please?
A typical 3D Clip Cube should work on symbols by default. Or are you talking about an X-Clip, or are you talking about Symbol Clip?
Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
While in the XClip menu make sure F6 Ignore Z is turned on. Xclips will sometimes clip out things if their zheights are abnormal. With Ignore Z on, it will display everything within the xclip regardless of it's Zheight.
Who is online
Users browsing this forum: No registered users and 3 guests