Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
#71663 by GARY247
Tue Jun 13, 2017 10:59 am
I have a drawing with multiple xreferences (9). Other than hitting the hot key "U" is it possible to hit the escape key to just regen the screen. Hitting the "u" key is time consuming when you have multiple xreferences and quite often half of the xref disappears when going from one function to another and I cannot get it back unless I refresh the xreference in question or hit "u". I looked in the ini file but did not see anything that referenced the escape key.
#71665 by GARY247
Wed Jun 14, 2017 10:53 am
I at one time changed the ini file so that when I hit the refresh key "u" it refreshed all the xreferences. When I have a file with multiple xreferences they disappear just by zooming out and then I have to hit the refresh key to get them back. I want to change this back to the default setting where I refresh xreferences manually only I do not remember which line to change to false. I am thinking a screen refresh would be quicker regeneration that refreshing the xreference.

Who is online

Users browsing this forum: No registered users and 5 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for Architects Since 1984