Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#72595 by Tony Goode
Wed Nov 01, 2017 12:07 pm
I get this error message whenever I try to move a line or any other entity to another layer; 'fault 10 Error from 808'
I have tried purging the drawing I was in when it first started which didn't work.
It now occurs in every drawing I open.
Any ideas, please.

Who is online

Users browsing this forum: No registered users and 29 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984