Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
#74785 by GARY247
Mon Sep 17, 2018 8:50 am
I am trying to use version 18 as a secondary program so can look and work on two different drawings at the same time. When I open a drawing in 18 it holds until I go to a different view and then it dumps. I had someone else open the drawing with a newer computer than mine and it worked fine.I tried to the layer sets and created a new drawing with the same results. I tried doing a repair but that did not work. Two questions. Is this a software or a computer problem?

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984