I am trying to use version 18 as a secondary program so can look and work on two different drawings at the same time. When I open a drawing in 18 it holds until I go to a different view and then it dumps. I had someone else open the drawing with a newer computer than mine and it worked fine.I tried to the layer sets and created a new drawing with the same results. I tried doing a repair but that did not work. Two questions. Is this a software or a computer problem?
Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
Who is online
Users browsing this forum: No registered users and 3 guests