Use this forum to ask questions about DataCAD 18 and DataCAD LT 18.
#75002 by Roger D
Thu Oct 11, 2018 2:51 pm
In DcadWin.ini file in the program directory, edit with notepad and change to False
1LineTrim By Entity=TRUE

; Controls the behavior of the Entity toggle in 1LnTrim.
; If TRUE, Entity is automatically reset to on.
; If FALSE, Entity is automatically reset to off.
; If blank, the Entity toggle will retain its last status.

A nice resource for these questions
Open and search by a term, I used "entity" to find this one.

Or, Program Preferences, Misc Tab, Lower Left area.
#75003 by David A. Giesselman
Thu Oct 11, 2018 2:55 pm

In the [General] section of the dcadwin.ini file, look for the following key:

1LineTrim By Entity=TRUE

That key can be set 3 ways:
  1. 1LineTrim By Entity=TRUE
    Entity will always be On when entering 1 Line Trim
  2. 1LineTrim By Entity=FALSE
    Entity will always be Off when entering 1 Line Trim
  3. 1LineTrim By Entity=
    Entity will remember its last state when entering 1 Line Trim

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984