Found a hidden feature or want to share a time-saving shortcut? Let us all know...
#74021 by Ted B
Sat Jun 02, 2018 11:16 pm
I've always used a diagonal* cross-hatch. Regular foam rigid insulation is typically shown as a square-on cross-hatch, so... For close-up large-scale details, l might add a stippled-dot overlay like "cement" or "gyp. drywall". Where there's an open exposed surface like when applied between or over rafters, I might use "treeline" as a boundry, redrawn if necessary to keep the bumpies on the outer exposed surface. Clarity of intent being more important than literal accuracy.

[*- 45 degrees to the adjoining edges/surfaces.]

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984