Hatch Patterns for insulations
Posted:
Sat Jun 02, 2018 3:45 pm
by Aaron Ben-Avraham
Just wondering what hatch patterns is the preferred choice for showing Closed Cell Spray foam and blown in Cellulose. Any tips appreciated.
Thanks!
Aaron
Re: Hatch Patterns for insulations
Posted:
Sat Jun 02, 2018 11:16 pm
by Ted B
I've always used a diagonal* cross-hatch. Regular foam rigid insulation is typically shown as a square-on cross-hatch, so... For close-up large-scale details, l might add a stippled-dot overlay like "cement" or "gyp. drywall". Where there's an open exposed surface like when applied between or over rafters, I might use "treeline" as a boundry, redrawn if necessary to keep the bumpies on the outer exposed surface. Clarity of intent being more important than literal accuracy.
[*- 45 degrees to the adjoining edges/surfaces.]