Found a hidden feature or want to share a time-saving shortcut? Let us all know...
#74328 by Neil Blanchard
Fri Jul 13, 2018 10:22 am
Hi Folks,

I just figured out how to workaround an issue, that you may have also run into - if you have a detail that uses a Clip Cube, you can use a symbol for the title bubble. By toggling on Ignore Clip Cubes, that symbol shows up outside the CC - but if the title needs to be longer than the line in the symbol, it looks wrong.

My workaround is to use a Smart Arrow with the arrow size set to zero, to extend the line - because Smart Arrows can also be set to Ignore Clip Cube. And a farther trick is to Copy the smart arrow (after you have toggled on the Ignore CC setting) to the clipboard - and paste it as needed. This lets you set the arrowhead size back to your standard.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984