Found a hidden feature or want to share a time-saving shortcut? Let us all know...
#35641 by artmanvt2000
Thu May 01, 2008 9:49 am
I have this little request. I wish that when setting up Multi Sheet Layouts, that the layout was determined based on sheet size, not printable area. There are issues when sending/using the files that are setup for a different printer/plotter. But before I go much further this change should not effect the display of the printable area. It is very beneficial to know what the printable area is, so we shouldn't loose it. I know I am asking to "have my cake and eat it too", but this adjustment would have it's advantages.

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984