DataCAD 19: applied "fieldstone" hatch to area with and without association. When applied hatch looks good but it will not move or mirror and cannot be edited. When I printed, it disappeared and I have no idea where it went. It is acting like the second line of a two-line wall. Any recommendations?
Is the layer locked that you are trying to hatch on?
Highest Regards,
Alan T. Hendry, RA
Intel i7-12700F (2.10 GHz) Desktop, 16GB RAM, 1TB SSD, Win 11 Home 64-bit, DC 23 w/ latest beta
Intel i7-10750H (2.6GHz) Laptop, 16GB RAM, 1.5TB HD, Win 11 Home 64-Bit, w/ DC 22, 23 & latest beta
Alan T. Hendry, RA
Intel i7-12700F (2.10 GHz) Desktop, 16GB RAM, 1TB SSD, Win 11 Home 64-bit, DC 23 w/ latest beta
Intel i7-10750H (2.6GHz) Laptop, 16GB RAM, 1.5TB HD, Win 11 Home 64-Bit, w/ DC 22, 23 & latest beta
Sometimes I have to laugh at myself. I never turn "Show Hatch on drawing" off, but somehow I did. Thanks for the help.
Ooo yah ... been there, slapped my forehead for doing it!
Highest Regards,
Alan T. Hendry, RA
Intel i7-12700F (2.10 GHz) Desktop, 16GB RAM, 1TB SSD, Win 11 Home 64-bit, DC 23 w/ latest beta
Intel i7-10750H (2.6GHz) Laptop, 16GB RAM, 1.5TB HD, Win 11 Home 64-Bit, w/ DC 22, 23 & latest beta
Alan T. Hendry, RA
Intel i7-12700F (2.10 GHz) Desktop, 16GB RAM, 1TB SSD, Win 11 Home 64-bit, DC 23 w/ latest beta
Intel i7-10750H (2.6GHz) Laptop, 16GB RAM, 1.5TB HD, Win 11 Home 64-Bit, w/ DC 22, 23 & latest beta
Who is online
Users browsing this forum: No registered users and 19 guests