Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#71503 by dennisnorton
Wed May 17, 2017 9:11 am
I am sure this has been discussed in the past, but can't find the solution...
I still have problems occasionally when I modify symbols. The updated symbols still show up incorrectly in the drawing where the symbol was corrected. I have tried regenerating, reloading, purging symbols, etc... but nothing seems to work. I open a new file and the symbol is correct, but the original file is still wrong. I have also tried editing the symbol for the particular drawing, but it just doesn't regenerate properly... What am I not doing correctly?

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984