Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#73360 by GARY247
Tue Mar 06, 2018 11:52 am
When create an attribute that is drawn as horizontal but rotate with the angle locked and fixed text and rotate it when you bring it in the plan the text shows up fine on the base drawing but when you use the base drawing as an xref the attribute reverts to being vertical. Is there a way to correct this short of having an attribute for each situation of x and y?
#73362 by joshhuggins
Tue Mar 06, 2018 2:38 pm
I am a little unclear in your message, but Ctrl+Right click on your xref and try toggling Fix Text. If that is not your intended result, check when inserting the symbol if Lock Angle is on or not and try the opposite.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984