Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#74848 by Bob Urbanek
Wed Sep 26, 2018 5:08 pm
Was working on a plan Datacad crashed. When I tried to re-open the file I got the standard "was not closed properly, etc" will now open most recent . Say OK, but it won't open. Just get the spinning circle. Tried to open ARF, and ARB--same thing. Tried file repair, same thing. Any suggestions?

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984