Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#79221 by mra
Tue Dec 22, 2020 9:46 pm
I'm trying to make a new hatch 3x12 running tile. I edited the cmu pattern in notepad but how do I convert to DHP?

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984