forum.datacad.com

This is an old problem - that my X and Y axes have gotten reversed - that keeps recurring. I know I’ve asked, and had answered, this problem before, but now that answer either doesn't work or isn't the answer:

Probably tangents is on. I think the command to turn it off is Geometry/Tangents/F3.

But there is no F3 in Tangents. Maybe a change in v19?

And I also don't know how I keep doing this...

Thanks,

David

If there is no F3 Cancel, then you do not have a Tangent adjustment set. You probably need to go to F0 Settings, F3 Angle Type, S1 Start Angle and click and drag in the direction you normally have North set to and click again. Usually you want to drag to the right or up.

Posting more to my own post:

Fixed it, sort of. At David Sargert’s wise suggestion, I exported the layers I need (fortunately only two at the moment) to a new base file.

But I’d still like to know what I did and how to fix it – cause you know it will happen again!

David