Page 1 of 1
Text line spacing...
Posted:
Mon Dec 19, 2016 1:49 pmby Tim Mohr
For some reason the default text line spacing (Line: 1) is stacking text directly on top of the line below it without any space between. I haven't changed any settings that I am aware of so this is something of a mystery...anyone have similar issues (DCAD 19)
Re: Text line spacing...
Posted:
Mon Dec 19, 2016 1:51 pmby Tim Mohr
should add that when I check properties for text in question it says that the text is set to "text:line feed" - turn that off it corrects the issue but there is no way to do this prior to inserting the text into the drawing (as best as I can tell) ...is this an ini issue?
Re: Text line spacing...
Posted:
Mon Dec 19, 2016 2:22 pmby David A. Giesselman
On the
Misc tab of the
Preferences dialog, uncheck these 2 options.
lf.JPG (80.88 KiB) Viewed 5920 times
Dave
Re: Text line spacing...
Posted:
Mon Dec 19, 2016 2:54 pmby Tim Mohr
thanks ...that did it
Re: Text line spacing...
Posted:
Thu Dec 22, 2016 10:32 amby mrupsis
Thanks for that tip Dave! That was driving me nuts since I installed 19 as well...especially with knock-out on,