Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#70494 by mrupsis
Thu Dec 22, 2016 10:42 am
Every since I installed 19, I cannot get "Get X + Distance" or "Get Y + Distance" to operate the way it did in 18. I just tried to stretch one edge of a building out approximately 2'-0", and tried to use Get Y + Distance, and it came up with a result of 40'-4" in the Y direction, no matter whether I inputted a positive or negative distance from the other corner. I've had weird results when tangents has been on as well. I love using this feature, and it's driving me nuts. Am I missing a setting somewhere? Get X and Get Y seem to be operating properly.

Thanks in advance....
Mark Rupsis

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984