Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#70501 by Neil Blanchard
Thu Dec 22, 2016 4:26 pm
This has been an issue for a while, but I am going to mention it (again?): I use Dir / Dis, and even though I have Ortho on, if I do a Stretch with a reference point, the stretch angle very often ends up really wonky.

The only way to get it right is to drag the cursor farther away than the distance I am stretching. If I move it somewhat less than the distance - it is like Ortho is not on at all. The angle seems to be where the cursor is. :?

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984