Number of Points Snapping
Posted: Thu Jan 05, 2017 4:38 pmIt doesn't seem that the number of points snap setting works on associative dims - is this correct?
That's correct. It could be added if needed.
Dave
forum.datacad.com
DataCAD Forum Hosted by DATACAD LLC
https://www.datacad.com/bbs/
Number of Points Snapping
Page 1 of 1
Posted: Thu Jan 05, 2017 4:38 pmRe: Number of Points Snapping
Posted: Thu Jan 05, 2017 4:40 pmRe: Number of Points Snapping
Posted: Fri Jan 06, 2017 9:12 amThis could be helpful sometimes.
Re: Number of Points Snapping
Posted: Fri Jan 06, 2017 9:29 amSo, Number of Points along the dimension line itself?
Re: Number of Points Snapping
Posted: Fri Jan 06, 2017 12:30 pmRe: Number of Points Snapping
Posted: Fri Jan 06, 2017 1:41 pmCorrect - this saves doing the math, in some situations.
Re: Number of Points Snapping
Posted: Fri Jan 06, 2017 1:49 pmDone for the next Subscription update.
Dave
Dave
Re: Number of Points Snapping
Posted: Fri Jan 06, 2017 2:22 pmUntil it is done you could just use divisions to put snap points along the dimension line to snap to and it should work the same.
Re: Number of Points Snapping
Posted: Fri Jan 06, 2017 2:41 pm