Page 1 of 1
Curved slabs
Posted:
Wed Feb 01, 2017 11:10 am
by mrupsis
It's been a long while since I've had to model a parking lot, but here I am... I for the life of me can't remember how to model curved sidewalks, curved curbs, etc. I have the curved slab macro, but it doesn't seem to work in 19. Can someone point me in the right direction?
Thanks,
Mark Rupsis
Re: Curved slabs
Posted:
Wed Feb 01, 2017 11:31 am
by Mark F. Madura
Curves --> Polyline
- Toggle Covered On
So you'll use 'Covered Polylines' to model curved slabs.
Re: Curved slabs
Posted:
Wed Feb 01, 2017 2:23 pm
by Paul Nida
Depending on what you are doing you might want to look at the sweep command in the 3d tools macro.
Re: Curved slabs
Posted:
Wed Feb 01, 2017 11:09 pm
by mrupsis
Thanks Mark! Exactly what I needed for the sidewalks.
Paul - I am going to try that for the curbs. Going to work on that tomorrow. Thanks for the tip!
Regards,
Mark