Page 1 of 1
Alternation symbol insert snapping
Posted:
Thu Feb 16, 2017 2:25 am
by cadline
Good Morning,
We seem to have lost the ability to snap to alternative insert points on symbols in the symbol browser.
Any advice is appreciated.
Regards, Eugene
Re: Alternation symbol insert snapping
Posted:
Thu Feb 16, 2017 3:00 am
by joshhuggins
Try a reboot?
Re: Alternation symbol insert snapping
Posted:
Thu Feb 16, 2017 7:57 am
by MtnArch
Check to make sure that "Layer Snap" is turned on under Utility\Object Snap, and that "Fast Symbol" is turned off under Utility\Object Snap\More Options.
Re: Alternation symbol insert snapping
Posted:
Fri Feb 17, 2017 1:05 am
by cadline
Rebooted without success?
Re: Alternation symbol insert snapping
Posted:
Fri Feb 17, 2017 1:42 am
by joshhuggins
Is F6 By Center turned on?
Re: Alternation symbol insert snapping
Posted:
Fri Feb 17, 2017 3:41 am
by cadline
That was the problem and is now turned off.
Thank you Josh