I have found where to change the type of ends to the lines you draw.
Open Line Type Menu
Pen Style
Solid S
Then I draw a line that has some thickness to it (.64mm to be exact) right next to the line that was already there (part of the title block), print to PDF, and BINGO! the end of the line I just drew is nice and square, just like I want it. Right next to the standard Solid R line with the rounded end.
THE PROBLEM IS.... I need to change every line in the drawing to this "solid S" but cannot figure out how. I already tried:
Change
Line Type
Solid
Area (crossing)
No good. Any help?
George
Open Line Type Menu
Pen Style
Solid S
Then I draw a line that has some thickness to it (.64mm to be exact) right next to the line that was already there (part of the title block), print to PDF, and BINGO! the end of the line I just drew is nice and square, just like I want it. Right next to the standard Solid R line with the rounded end.
THE PROBLEM IS.... I need to change every line in the drawing to this "solid S" but cannot figure out how. I already tried:
Change
Line Type
Solid
Area (crossing)
No good. Any help?
George