Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#71059 by George W. Burns CPBD
Fri Mar 24, 2017 12:06 pm
I am trying to add poche to my walls. I set up my pen table so that Lt. Cyan is .17 @ 40% and mapped to black. So I hit "H", clicked on "SPB-fill", clicked on "boundary", and clicked inside my walls on my floor plan. Even though I have my A-EXIST-WALL-FILL layer's color set to Lt. Cyan, the fill on my screen is WHITE. So I alt-Identify the white fill, and the color reported is ...... LT CYAN!!! What? CLEARLY it is white. So I said.... "whatever" and printed to PDF real quick to see what is going on. This is what I get:
Image
So then I notice there is a "settings" button on the fill menu. I clicked on it and set (in the Solid Pattern Fill section, which IS checked) the Pattern Color to entity NOT checked, and set the color to Lt. Cyan. Then I went back and erased all the white fill and filled again. this time the fill was indeed Lt. Cyan. But IT ALSO PRINTS TO PDF LT. CYAN!!!!! Not 40% black screen like that pen color is mapped to. What am I doing wrong?
Image

FWIW, the walls (2 lines) are drawn with red, which is set at .45 @ 100% mapped to black, and white, which is what the image shows the SPF is, is .35 @ 100% mapped to black.
Attachments
(72.79 KiB) Downloaded 19 times

Who is online

Users browsing this forum: No registered users and 1 guest

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984