Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
Why does some hatch not display and others do? Every time I go to plot I have to insure that the layers are loaded... Is there a setting per layer for hatch display?
not per layer.
You might check Program Preferences/Misc. Tab and make sure "All" is checked for Hatch.
Roger Donaldson AIA CSI CDT LEED AP BD+C NCARB
abUsing Datacad since 1986, ver 19.03.00.10 (SE)http://www
Thanks for the suggestion... Hatching was in fact selected, so still no solution.
One item I forgot to mention - this occurs with XREFs only.
Are the XRef's clipped? If so, is Ignore Z toggled on for the X-Clip? If this fixes it, then you can change Z-height / Base in the XRef'd file to 0.
Who is online
Users browsing this forum: No registered users and 2 guests