forum.datacad.com

Hi folks,

I use Layer Sets from time to time, as a way to move/create groups of layers AND the associated GTV's to another drawing.

The issue I have is when you select On Layers, and either Views and/or Details toggled on - and you get ALL the layers, anyway.

What I was expecting to happen was to have only the GTV's and MSP Details associated with the On Layers be included in the Layer Set. Is this possible?

Since the File/Import command became available, I know load sheets, details, GTV and Layers and can select what other layers that may be needed.
This way, if a file has been updated, you do not need to save out the Layer Set again before loading the layer set, just suck the layers over is one step.

Thanks for the reply, Roger. I think that is what is going on, but it should be clearer what is going to happen.