Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#71818 by Neil Blanchard
Mon Jul 10, 2017 8:59 am
Hi folks,

I use Layer Sets from time to time, as a way to move/create groups of layers AND the associated GTV's to another drawing.

The issue I have is when you select On Layers, and either Views and/or Details toggled on - and you get ALL the layers, anyway.

What I was expecting to happen was to have only the GTV's and MSP Details associated with the On Layers be included in the Layer Set. Is this possible?
#71819 by Roger D
Mon Jul 10, 2017 11:43 am
Since the File/Import command became available, I know load sheets, details, GTV and Layers and can select what other layers that may be needed.
This way, if a file has been updated, you do not need to save out the Layer Set again before loading the layer set, just suck the layers over is one step.

Who is online

Users browsing this forum: No registered users and 45 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984