forum.datacad.com

Hi,

I am using the newest version - v19.01.00.16 (SE) and I drew several Smart Arrows, and then I used Undo to erase one. The next one that I drew lost the infill setting and the aspect changed from 5 to 3.



The last arrow is near the cursor.

I couldn't recreate this. Are you using a macro to start the arrow creation? Did you ctrl+z for the undo while still in the create arrow command?

I often use a keyboard shortcut to get to the Smart Arrow menu:



This happened again in a different file, in different circumstances. So, I am not sure how / if I can reproduced it. I opened this file, and changed to a GTV, and added a Paratext note, and then used the Smart Arrow menu on the menu.