Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#71942 by joshhuggins
Thu Jul 27, 2017 12:32 pm
I couldn't recreate this. Are you using a macro to start the arrow creation? Did you ctrl+z for the undo while still in the create arrow command?
#71944 by Neil Blanchard
Thu Jul 27, 2017 12:47 pm
I often use a keyboard shortcut to get to the Smart Arrow menu:

Code: Select allR^14#^S7^S2
//Arrows


This happened again in a different file, in different circumstances. So, I am not sure how / if I can reproduced it. I opened this file, and changed to a GTV, and added a Paratext note, and then used the Smart Arrow menu on the menu.

Who is online

Users browsing this forum: No registered users and 45 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984