Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#71951 by 2mackids
Sat Jul 29, 2017 4:08 pm
Hello all,

I just installed v.19 and have been able to set it up successfully w/ all of my templates, defaults, etc. (I was currently on v.13). I'm dimensioning things and keep noticing these circles which show up at the endpoint, midpoints, etc, but then disappear after I've clicked. How do I turn these circles off? They distract me.
#71952 by Roger D
Sun Jul 30, 2017 11:17 am
Program Preferences
Drawing Tab
Drawing Indicators
uncheck "Show current Reference Point"
#71957 by 2mackids
Mon Jul 31, 2017 9:10 am
I found it. It was actually under "Dynamic Snapping", but thank you. The one you'd mentioned was already unchecked.

Who is online

Users browsing this forum: No registered users and 20 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984