Page 1 of 1

Circle displays

PostPosted: Sat Jul 29, 2017 4:08 pm
by 2mackids
Hello all,

I just installed v.19 and have been able to set it up successfully w/ all of my templates, defaults, etc. (I was currently on v.13). I'm dimensioning things and keep noticing these circles which show up at the endpoint, midpoints, etc, but then disappear after I've clicked. How do I turn these circles off? They distract me.

Re: Circle displays

PostPosted: Sun Jul 30, 2017 11:17 am
by Roger D
Program Preferences
Drawing Tab
Drawing Indicators
uncheck "Show current Reference Point"

Re: Circle displays

PostPosted: Mon Jul 31, 2017 9:10 am
by 2mackids
I found it. It was actually under "Dynamic Snapping", but thank you. The one you'd mentioned was already unchecked.