Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#72049 by joshhuggins
Wed Aug 09, 2017 11:03 am
Not seeing that here? :? I created aligned dims with both Fixed Inc on and off, then turned Fixed Inc off and then Alt+I [I^·^È^;^S1^$^S8^S0^É^] on each one and then went into the dimension menu and Fixed Inc remained turned off for both. Could there be something else you're doing I may not be?
Last edited by joshhuggins on Thu Aug 10, 2017 10:47 am, edited 1 time in total.

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984