forum.datacad.com

And I'm sure it's because I don't understand how it works, but when I hit the "P" key, the message down on the lower left:
"No view to restore (Up to 25 views are saved)"

I am working on cabinet elevations and I am scrolling/panning from the floor plan to the cab. eles, and it would be so much faster just to hit the "P" key like I always have in the past, but for some reason, it doesn't work anymore. What am I doing wrong?

In the Program Prefs, on the Interface tab double check to see if both options are checked under Previous view. Also sometimes it can break and just stop working which requires restarting Datacad, but that is rare.