Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#72569 by esme103
Wed Oct 25, 2017 8:17 pm
Somehow I reduced the grid that appears on the screen to the bottom left which makes it difficult to place a 2' x 3' Title Block on the sheet. How do I correct this?

In advance, thank you for your help.

:) Esme
#72571 by Mark Bell
Thu Oct 26, 2017 5:25 am
Hi Esme,

If I understand you right, try adjusting the Layout Divisions in the MultiLayout\Settings\Layout Divs (F1) as this allows you to change the grid spacings for the MSP sheets. F4 Snap to Divisions also you to accurately snap and place your drawing sheet so it's the same across all MSP's.
#72572 by Roger D
Thu Oct 26, 2017 7:25 am
Can also try under Muli-layout / Settings / Layout %, set it to 100%

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984