Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#73186 by Bob Urbanek
Wed Jan 31, 2018 1:25 pm
When taking a measurement, or doing a dimension, if I am not really careful, I snap to a point that isn't there. In the case of a wall intersection, it will snap 1/4" or 3/4" away from the actual intersection.I have looked at all the settings, but can't find the problem. Looked at the mouse settings also.

Who is online

Users browsing this forum: No registered users and 2 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.


Software for AEC Professionals Since 1984