Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#73200 by Roger D
Fri Feb 02, 2018 3:17 pm
Rod Walker (rodwalks@westnet.com.au) was working on a DrwTruss Macro that would do that, I have a demo that doesn't work any more.
#73215 by ORWoody
Mon Feb 05, 2018 9:52 pm
Just a quick remembrance of Rod... he was deadly sharp in his macro programming for DataCAD. Anything that he did was as good and clean as anything could be. That macro that Rod mentioned was beautiful to behold. I'd like to be a tenth as good as Rod was.
He's missed.
Woody
#73220 by ORWoody
Tue Feb 06, 2018 8:07 pm
I doubt that Rod's family has any way to get that for you. He passed away several years ago so by now, all has probably been cleared away.
Woody

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984