Page 1 of 1

open web wood joists

PostPosted: Fri Feb 02, 2018 2:56 pm
by GARY247
Is there anything within the macros to automatically generate bottom bearing open web wood joists?

Re: open web wood joists

PostPosted: Fri Feb 02, 2018 3:17 pm
by Roger D
Rod Walker (rodwalks@westnet.com.au) was working on a DrwTruss Macro that would do that, I have a demo that doesn't work any more.

Re: open web wood joists

PostPosted: Mon Feb 05, 2018 9:52 pm
by ORWoody
Just a quick remembrance of Rod... he was deadly sharp in his macro programming for DataCAD. Anything that he did was as good and clean as anything could be. That macro that Rod mentioned was beautiful to behold. I'd like to be a tenth as good as Rod was.
He's missed.
Woody

Re: open web wood joists

PostPosted: Tue Feb 06, 2018 3:07 pm
by GARY247
Not sure but I am guessing that that macro is not available. Is this correct?

Re: open web wood joists

PostPosted: Tue Feb 06, 2018 8:07 pm
by ORWoody
I doubt that Rod's family has any way to get that for you. He passed away several years ago so by now, all has probably been cleared away.
Woody