Page 1 of 1
printer setup
Posted:
Mon Feb 19, 2018 10:44 amby Bob Urbanek
When I setup the number of copies to print,it only works once. It used to remember the amount of copies until I either manually changed them, or I restarted DCAD.
I looked in the DCAD ini, but couldn't find anything.
Re: printer setup
Posted:
Mon Feb 19, 2018 5:32 pmby David A. Giesselman
Re: printer setup
Posted:
Tue Feb 20, 2018 5:38 pmby Bob Urbanek
I just had something I needed to print. I set up to make 3 copies. When I saw the preview, I noticed I had missed something.Closed the previewer, made the change, gave the print command again, checked the setup and found that it had reverted to one copy.
It never used to do this. I have experienced a number of odd things happening, since I upgraded to V19.
Bob
Re: printer setup
Posted:
Sun Feb 25, 2018 11:08 pmby Bob Urbanek
I had taken advantage of the deal to upgrade to V19 before the first of the year. I just recently noticed that there was an update available. I did the update, and it seems to have rectified the problem.
Bob