Ask questions about DataCAD 20, DataCAD LT 20, or previous versions here.
#74132 by Bob Urbanek
Sat Jun 16, 2018 6:21 pm
MADE A RUN OF CABINETS------MADE TOPS------ CREATED VOID-------INSTALLED STAINLESS SINK ------FAUCET AND STRAINER VISIBLE IN 3D-----BOWL NOT VISIBLE----------MOVE SINK ASSEMBLY OUT OF CABINETS-------BOWL VISIBLE( AT LEAST PARTIALLY) MOVE SINK ASSEMBLY BACK----- BOWL NOT VISIBLE ??????????????
#74134 by Bob Urbanek
Sun Jun 17, 2018 2:08 pm
Actually, what is happening, is that you can see the bowl from a bottom or side view, but not from the top. It does not render the sink bowl, or sink top when viewing from the top. I have render both faces on. I also have trouble with other 3D symbols, ie. toilet tank top not rendering. What am I missing?

Who is online

Users browsing this forum: Google [Bot] and 31 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for Architects Since 1984