Page 1 of 1
dimension problem
Posted:
Thu Oct 11, 2018 12:57 pmby Bob Urbanek
Something happened -again. I have been using the same method to dimension since DCAD5. Didn't change anything. When I dimension something, the witness line would stay anchored where I snapped to and I would drag the dimension line down to where I wanted it.Now the witness line is offset considerably from where I snapped to. I have tried to change settings, and I can't fix it. What am I missing? I can go to older drawings, and it still works correctly. Any suggestions?
Re: dimension problem
Posted:
Thu Oct 11, 2018 1:32 pmby Roger D
Maybe Fixed Incr. got turned on under Dim. Style
Re: dimension problem
Posted:
Thu Oct 11, 2018 1:37 pmby joshhuggins
Maybe also check under Object Snaps that Offset is turned off.
Re: dimension problem
Posted:
Fri Oct 12, 2018 12:25 pmby Bob Urbanek
Thanks Roger and Josh,
After I posted yesterday, I just got frustrated and shut down for a few hours. When I started up again, the problem was gone. ?????
Thanks for your help.
Bob