Use this forum to ask questions about DataCAD 19 and DataCAD LT 19.
#75799 by Lars
Tue Feb 26, 2019 3:03 pm
I'm attempting to show a 45 degree corner door entrance for a library and am having problems with creating a partial height opening at the two intersecting 3D exterior smart walls. I've tried to use a door object with everything turned off, but this still leaves wall cap/cut lines at the end of each wall (the corner shows a "V" ). I've also tried to create an additional 3D wall above the corner "opening" which works great in 3D view however, in 2D plan view, there appears to be a wall where there isnt one.

Can I set my plan cut height for the model so the walls above do not show?

(Architect>Openings) creates a full height void. Why isnt there a way to set Z-base and Z-height constraints for this tool? AND editing the opening after its created would be nice also.

Who is online

Users browsing this forum: No registered users and 3 guests

About DataCAD Forum

The DataCAD Forum is a FREE online community we provide to enhance your experience with DataCAD.

We hope you'll visit often to get answers, share ideas, and interact with other DataCAD users around the world.

DataCAD

Software for AEC Professionals Since 1984